Match Grade Bushing Hornady

Product Description

The Hornady match Grade Dies feature interchangeable neck sizing bushings that are self centering. The bushings allow the user to size the case neck to the bullet tension you desire. This eliminates the chance of over-sizing your case necks and overworking the brass. Bushings are available in .002 inch increments. The Match Grade Full Length Die will size the case body, bump the shoulder and size the case neck with the selected bushing. The Match Grade Neck Die sizes the neck with the installed bushing and bumps the shoulder only (no body sizing). Both versions feature a self centering decap spindle with an o-ring spindle tensioner, and the elliptical expander ball with headed decap pin - the same pin used in the Custom Grade Dies. These bushing sizer dies have some unique features and are very well made and finished.

Product Description

Can't Load With RCBS GMM Dies Without One

RCBS Steel Neck Bushings are interchangeable to let the reloader select a bushing that gives precisely the right amount of tension on the bullet when using RCBS Gold Medal Match sizing dies. Using a precisely fitted Steel Neck Bushing reduces work hardening of the case neck brass, prolonging case life and helping to improve accuracy.

• Self-centering for proper alignment with case neck
• For best results, the use of high-end brass with consistent neck thicknesses is recommended
• Bushings come "in-the-white" - bare steel - so traditional case lubrication is required
• For use ONLY with RCBS Gold Medal sizing dies

RCBS recommends having neck bushings one to two sizes above and below your target diameter (see note below). RCBS Steel Neck Bushings are a small but critical component in loading extremely consistent-shooting ammo with your Gold Medal Match sizing dies.

Brownells Gun Tech™ Tip: There are two ways to select the steel neck bushings you need: (1) Measure the outside neck diameter of your loaded cartridge and subtract .002" to .003". This allows approximately .001" of brass to spring back for correct neck tension. (2) You can also measure the neck wall thickness of your case, multiply by two, add the diameter of your bullet and subtract .002" to .003".
 

Product Description

Sinclair Carbide Neck Sizing Bushings are very popular among benchrest shooters because they are smoother, harder, and available in ½ thousandths increments. These bushings have a small radius on the down side only, and should not be used upside down. These carbide bushings will fit L.E. Wilson and Redding dies. Currently only available in popular 6mm sizings.